Why is my resin print stuck to the vat film?
The first layers cured but released from the plate. Stop and remove cured debris using the printer's documented vat-clean method before another run.
Check that the plate is secured and calibrated by the manual, the correct resin profile was used, resin temperature is inside its stated range and the plate is clean. Compare bottom exposure and layer count with the maker's current starting settings. Phrozen says dents, scratches, deformation and increasing failure rates can indicate film replacement is due.
Do not change exposure, lift and levelling together. Record one change and retry a small model.
Sources
- Anycubic resin profiles — accessed 15 November 2026.
- Phrozen film inspection guidance — accessed 15 November 2026.
Related guides
Understand what the three vat-film names mean, why printer compatibility outranks generic claims, and when damage or rising failure rates justify inspection and replacement.
TroubleshootingTroubleshooting failed resin prints without changing everythingDiagnose plate adhesion, layer separation, support failure, suction cups, cloudy surfaces and cracks by locating the first bad layer and changing one controlled variable.