Direct answers
Knowledge base
Short answers first, with the source and the practical limit underneath.

No. The wash water contains uncured photopolymer; keep it contained and use the disposal route specified by the resin maker and your local authority.
Safety and workspaceDo I need nitrile gloves for resin printing?Use the glove material and change interval required by the exact resin and cleaner SDS; nitrile is commonly specified, but fit, thickness and compatibility matter.
Safety and workspaceCan I use a resin printer in a bedroom?A bedroom is a poor location because printing, washing and waste handling create chemical exposure routes in a space used for prolonged occupancy and sleep.
Safety and workspaceDoes a carbon filter make resin printing safe?No single filter establishes safety. Carbon can reduce some odour, but control depends on the chemical, capacity, airflow, replacement condition and the whole process.
Printing and post-processingHow long should I cure a resin print?Use the exact resin maker's post-cure instructions for its colour, part thickness, wavelength and equipment; there is no universal duration.
TroubleshootingWhy is my resin print stuck to the vat film?If the cured base is on the film and nothing is on the plate, check the official profile, plate setup, resin condition and film before increasing exposure.
TroubleshootingWhen should I replace resin printer FEP film?Replace film when the maker's inspection criteria or damage require it, not after an invented universal print count.
Choosing a printerWhat is the difference between screen resolution and XY resolution?Screen resolution counts LCD pixels; XY resolution or pixel pitch describes their projected size on the build area and is usually the more useful detail comparison.
Choosing a printerDo monochrome resin printer LCD screens last forever?No. The masking LCD is a consumable component; use the maker's warranty and replacement guidance instead of an unsourced universal lifespan.
Printing and post-processingShould I hollow resin miniatures?Usually not automatically. Small miniatures may save little resin while gaining trapped-liquid, drainage and weak-wall problems.
TroubleshootingWhy do hollow resin prints crack?Trapped liquid resin or wash fluid, weak walls, inadequate drainage and cure stress are possible causes; contain a leaking part and review the slice.
Safety and workspaceCan I use IPA in an ultrasonic cleaner?Do not use flammable IPA in equipment unless that exact equipment and process are explicitly designed and rated for it and the makers' instructions permit it.
TroubleshootingWhy is my resin print sticky after curing?A sticky surface can follow incomplete washing, a saturated bath, retained cleaner, incompatible processing or inadequate cure; diagnose the wash before adding UV.
Printing and post-processingCan I leave resin in the vat between prints?Follow the printer and resin maker's storage instructions; protect the vat from light, contamination, temperature extremes, children and pets, and inspect before reuse.
Printing and post-processingShould I use CHITUBOX or Lychee Slicer?Use the slicer with a maintained profile and export format for your exact printer, then compare support, hollowing and layer-preview workflow on your files.