How long should I cure a resin print?
There is no universal curing time. Use the exact resin maker's instructions for the resin, colour, part thickness, light wavelength and station.
Anycubic's Wash & Cure 3 Plus manual identifies a 405 nm system, while Elegoo describes 405 nm LEDs on Mercury Plus V3.0. Their timers provide a range, not a prescription for every material. Wash and dry the part fully first, space models so they do not shade one another and rotate a complex piece if required.
Adding time blindly can heat or embrittle a thin part, while shaded cavities may remain untreated. Hollow models need a maker-supported internal cleaning and cure strategy.
Sources
- Anycubic Wash & Cure 3 Plus manual — accessed 15 November 2026.
- Elegoo Mercury Plus V3.0 — accessed 15 November 2026.
Related guides
Compare Elegoo Mercury Plus V3.0 and Anycubic Wash & Cure 3 Plus by published washing and curing capacity, then decide whether separate stations suit you better.
Printing and post-processingWashing and curing resin prints without losing control of wasteA step-by-step post-processing workflow for draining, two-stage washing, support removal, drying, UV post-cure and segregating contaminated liquids and solids.
Printing and post-processingResin supports, orientation and hollowing: a layer-by-layer methodOrient resin models by cross-section and visible surfaces, support every island through a load path, and hollow only with drain and vent openings that work during print and wash.