Can I leave resin in the vat between prints?
Only if the printer and resin maker allow it and the vat can remain protected from light, contamination, unsuitable temperatures, children and pets. The original bottle is normally the controlled long-term container.
Before reuse, inspect for cured fragments after any failure, check the release film and mix the resin by the maker's method without damaging the film. A cover does not prevent all ambient light or spills. For a long pause, filter and return resin only if the maker documents that procedure, using a clean labelled bottle and chemical controls.
Keep the SDS and storage temperature instructions with the resin.
Sources
- Elegoo Mars 5 Ultra page — accessed 15 November 2026.
- HSE SDS guidance — accessed 15 November 2026.
Related guides
Compare Elegoo Mercury Plus V3.0 and Anycubic Wash & Cure 3 Plus by published washing and curing capacity, then decide whether separate stations suit you better.
Printing and post-processingWashing and curing resin prints without losing control of wasteA step-by-step post-processing workflow for draining, two-stage washing, support removal, drying, UV post-cure and segregating contaminated liquids and solids.
Printing and post-processingResin supports, orientation and hollowing: a layer-by-layer methodOrient resin models by cross-section and visible surfaces, support every island through a load path, and hollow only with drain and vent openings that work during print and wash.